Pc Case Side Fan Intake Or Exhaust

You will also be able to identify the exhaust side as you will see power wires entering the fan motor.

Pc case side fan intake or exhaust.

A single intake fan with no exhaust fan is positive pressure. Manage your cables and other obstructions. Pets bugs and. I would think that the number of intake fans should be more than the number of exhaust fans like you said.

The power supply is probably drawing air from an aperture in the base of the case and so is isolated and not really affecting the case s airflow the arrow for that one should probably be a right angle feeding in from the bottom and turning left to point out of the back of the psu. Reverse the fan in the top of the case to make it an extractor and make the side panel an intake. Since i have a liquid cooler they only put in one 120mm top fan because that is all that would fit. The graph below shows that the side panel fan still continues to have a massive positive effect on cooling even with three fans installed the three setups that performed the best in this test all included a side panel fan.

Side mounted fans can be intake or exhaust depending on the setup. I ran with 2 exhaust fans on top but because my push pull radiator setup is on the front as an intake due to better temps my top fans are intake for the motherboard and have a fan profile to slow them s own slightly. The side fan forces air directly onto the hottest component the video card which is then swept up by the airstream produced by the front fan and escorted out of the rear exhaust fan. However at the same time keeping the side panel open exposes the pc to new problems such as an increase in dust settling on hardware.

The intake exhaust direction should go front to back and bottom to top. Different flow affects dust build up just as much as the case and house itself. I still have good positive pressure in my case and temps are 2 to 4 degrees better than when i ran the top as exhausts. The top fan is an exhaust and bottom fan is an intake.

The side with the guard motor support lastly the fan airflow can be identified by the arrow markings on the fan. They also all included either a roof or rear exhaust fan which couples up well with our findings from out two fan. And they put in a 140mm side fan. Of course there s the cpu and gpu coolers as well as the psu playing into it.